Threaded Mode | Linear Mode

**RHennin** · 09-06-2010, 08:24 PM

(09-06-2010 04:12 PM)93redfox Wrote:
(09-06-2010 02:22 PM)JB Wrote: So much for being the first running G with a 2JZ, it was a good try though

http://www.supraforums.com/forum/showthr...p?t=602526

still got a shot at first sedan though, right?

I looked through that thread and it looks decent, but I'm not 100% sold on all the work. A few things like non molded end-tanks on the intercooler, intercooler fans? (yes, I know the bumper limits direct airflow, but still) and the engine bay is a little busier. Nothing bad, but I'll give TDC some credit since there's looks better at this point.

Cam@TDCauto · 11-04-2010, 02:01 PM

Here is some of the progress that has been going on with our G35 Sedan 2JZ project.

All of the intercooler piping has been made. We used 3" inch aluminum piping through out the whole thing. We also have a 4" intake for the turbo that has been made too.
[Image: 11-4-103.jpg]

Down-pipe is in the process of being made. This will be a 3" down-pipe that will run into the original G35 3" exhaust that was on the car.

[Image: 11-4-102.jpg]

And the driveshaft is out being made at Carolina Driveshafts. This will be a 1 piece driveshaft that will have a R154 side and a G35 differential side for the completed shaft.

[Image: 11-4-10.jpg]

**93redfox** · 11-04-2010, 02:49 PM

just curious, why the move to the 1 piece driveshaft?

top dead center · 11-04-2010, 06:14 PM

More strength, and it had to be custom fabbed anyway.

Cam@TDCauto · 11-08-2010, 11:33 AM

Downpipe is complete and the S14 gas pedal was installed to do away with the drive by wire system.

[Image: 11-5-10.jpg]

**93redfox** · 11-08-2010, 12:15 PM

is it just the picture, or is the pedal spacing a little akward?

dave99rt · (This post was last modified: 11-10-2010 02:08 PM by dave99rt.)

(11-08-2010 12:15 PM)93redfox Wrote: is it just the picture, or is the pedal spacing a little akward?

no heel-toe for you!

clemsonhatch · 11-10-2010, 10:09 PM

(11-10-2010 02:07 PM)dave99rt Wrote:
(11-08-2010 12:15 PM)93redfox Wrote: is it just the picture, or is the pedal spacing a little akward?

no heel-toe for you!

but plenty of soup Tongue

Cam@TDCauto · (This post was last modified: 11-11-2010 10:33 AM by Cam@TDCauto.)

BOV on and Intake Made!

[Image: 11-9-10.jpg]

(11-08-2010 12:15 PM)93redfox Wrote: is it just the picture, or is the pedal spacing a little akward?

Throttle cable wasn't hooked up either when I took that picture so it might be a reason why it looks a little funny.. Ill have another one today now that the throttle cable setup is complete.